Setting the SCSI ID and the SCSI Terminator
The default of SCSI ID is 5. SCSI ID is set by Setup mode of operator panel. The procedure to change SCSI ID is;
1Turn the power ON by pressing “I” side of the power switch (see Figure 1.1). The scanner displays “Scanner Ready” on the lower line of LCD.
2Then press “Next” 
button. The scanner displays “Mode select 1”.
3Then press “Next” 
button twice. The scanner displays “Mode select 2” meaning that setup mode is ready.
4Then press “Enter” button several times. The scanner displays as follows.
5Press “Next” 
around times, then the scanner displays “SCSI ID” on the upper line of the LCD.
6Select SCSI ID by pressing “
”or “
” button, and press “Enter”. (SCSI ID is set.)
7Press “Exit” to return to “Scanner Ready” screen if you don’t Need to change terminator.
NOTICE
If no other devices are using the same SCSI ID, the scanner ID does not have to be changed.
NOTICE
The new ID does not take effect until the system power is turned on again.
