Fujitsu C2111, C2010 manual Video Problems, page 8 for location

B5FH-5971.book Page 78 Thursday, May 23, 2002 4:13 PM

L i f e B o o k C S e r i e s N o t e b o o k – S e c t i o n S i x

Problem	Possible Cause	Possible Solutions
Video Problems
Display is blank when	Something is pushing on the	Clear the Closed Cover switch. (See figure 2-3 on
you turn on the system.	Closed Cover switch.	page 8 for location)
	The LifeBook notebook is set for	Pressing [F10] while holding down the [Fn] key
	an external monitor only.	allows you to change the destination of your display
		video. Each time you press the combination of keys
		you will step to the next choice. The choices, in
		order are: built-in display only, external monitor
		only, both built-in display and external monitor.
	The angle and brightness settings	Move the display and the brightness control until
	of the display are not adequate for	you have adequate visibility.
	the lighting conditions.
	The power management timeouts	Press any button the keyboard, or move the mouse
	may be set for very short intervals	to restore operation. If that fails, push the Suspend/
	and you failed to notice the	Resume button. (The display may be shut off by
	display come on and go off again.	Standy mode, Auto Suspend or Video Timeout)
When the ATI Driver	The warning does not apply to	If this message appears on your screen, click the
CD is first installed, you	your Fujitsu LifeBook; the driver	Continue Anyway or Yes buttons to proceed.
receive a Microsoft	has been thoroughly tested and its
message informing you	installation will not jeopardize
that the ATI driver is not	the performance of your system.
compatible with your
operating system.
The LifeBook notebook	Power On Self Test (POST) has	Contact your support representative.
turned on with a series	detected a failure which does not
of beeps and your built-	allow the display to operate.
in display is blank.
The display goes blank	The LifeBook notebook has gone	Press any button on the keyboard, or move the mouse
by itself after you have	into Video timeout, Standby	to restore operation. If that fails, push the Suspend/
been using it.	mode, Suspend mode or Hiber-	Resume button. Check your power management
	nation (Save-to-Disk) mode	settings, or close your applications and go to the
	because you have not used it for a	Power Savings menu of the setup utility to adjust the
	period of time.	timeout values to suit your operation needs. (See
		BIOS Setup Utility on page 27 for more information)
	Something is pushing on the	Check the Closed Cover switch. (See figure 2-3 on
	Closed Cover switch.	page 8 for location)
	The power management timeouts	Press any button on the keyboard, or move the mouse
	may be set for very short intervals	to restore operation. If that fails, push the Suspend/
	and you failed to notice the	Resume button. (The display may be shut off by
	display come on and go off again.	Standby Mode, Auto Suspend or Video Timeout)
The Built-in Display	A foreign object, such as a paper	Remove all foreign objects from the keyboard.
does not close.	clip, is stuck between the display
	and the keyboard.
The Built-in Display has	If the spots are very tiny and few	This is normal; do nothing.
bright or dark spots.	in number, this is normal for a
	large LCD display.

78