Fujitsu C2010, C2111 manual Shutdown and Startup Problems, Utility on page 27 for more information

B5FH-5971.book Page 77 Thursday, May 23, 2002 4:13 PM

		T r o u b l e s h o o t i n g
Problem	Possible Cause	Possible Solutions
The batteries seem to	The power savings features may	Check the power management and/or setup utility
discharge too quickly.	be disabled.	settings in the Power Savings menu and adjust
(continued)		according to your operating needs.
	The brightness is turned all	Turn down the brightness adjustment. The higher
	the way up.	the brightness the more power your display uses.
	The batteries are very old.	Replace the batteries.
	The batteries have been exposed	Replace the batteries.
	to high temperatures.
	The batteries are too hot or too	Restore the LifeBook to normal operating tempera-
	cold.	ture. The Charging icon on the indicator panel will
		flash when the battery is outside operating range.
Shutdown and Startup Problems
The Suspend/Resume	The Suspend/Resume button is	Enable the button from the setup utility.
button does not work.	disabled from the Advanced
	submenu of the Power menu of
	the setup utility.
	You did not hold the button in	Hold the button longer. This may need to be a few
	long enough.	seconds if your application is preventing the CPU
		from checking for button pushes.
	There may be a conflict with the	Close all applications and try the button again.
	application software.
The system powers up,	The boot sequence settings of the	Set the operating source by pressing the [ESC] key
and displays power on	setup utility are not compatible	while the Fujitsu logo is on screen or use the [F2]
information, but fails to	with your configuration.	key and enter the setup utility and adjust the source
load the operating		settings from the Boot menu. (See BIOS Setup
system.		Utility on page 27 for more information)
	You have a secured system	Make sure you have the right password. Enter the
	requiring a password to load your	setup utility and verify the Security settings and
	operating system.	modify them as accordingly. (See BIOS Setup Utility
		on page 27 for more information)
	Internal hard drive was not	Use the BIOS setup utility or Primary Master
	detected.	submenu, located within the Main menu, to try to
		auto detect the internal hard drive.
An error message is	Power On Self Test (POST) has	See Power On Self Test (POST) messages to deter-
displayed during the	detected a problem.	mine the meaning of the problem. Not all messages
LifeBook notebook		are errors; some are status indicators. (See Power On
(boot) sequence.		Self Test Messages on page 80 for more information)
Your LifeBook note-	BIOS setup changes were not	Make sure you select Save Changes And Exit when
book appears to change	saved when you made them and	exiting the BIOS setup utility.
setup parameters when	exited the BIOS setup utility
you start it.	returning it to previous settings.
	The BIOS CMOS hold-up battery	Contact your support representative for repairs.
	has failed.	This is not a user serviceable part but has a normal
		life of 3 to 5 years.

77