Fujitsu E8410 manual Power Failures, Setup Utility on

Problem	Possible Cause	Possible Solutions
A card inserted in the PC	Your software may not	See your software documentation and activate the correct driver.
Card or ExpressCard slot	have the correct soft-
does not work or is locking	ware driver active.
up the system.
	You may have the	See your PC Card/ExpressCard documentation to determine the
(continued)
	wrong I/O address	required I/O address. Change the settings in the BIOS. See “BIOS
	selected for your card	Setup Utility” on page 54.
	device.
	Your card device and	Check all I/O addresses located within the BIOS setup utility and
	another device are	any other installed hardware or software to make sure there are
	assigned the same I/O	no duplications.
	address.
Power Failures

You turn on your LifeBook notebook and nothing seems to happen.

The installed primary	Check the Status Indicator Panel to determine the presence and
battery is completely	condition of the batteries. See “Status Indicator Panel” on
discharged, there is no	page 24. Install a charged battery or a Power adapter.
optional second battery
installed or there is no
Power adapter (AC or
Auto/Airline) installed.
The primary battery is	Use the Status Indicator panel to verify the presence and condi-
installed but is faulty.	tion of the batteries. See “Status Indicator Panel” on page 24. If a
	battery is indicating a short, remove that battery and operate from
	another power source or replace that battery.
The battery or batteries	Check the Status Indicator Panel to determine the presence and
are low.	condition of the batteries. See “Status Indicator Panel” on
	page 24. Use a Power adapter to operate until a battery is
	charged or install a charged battery.
The power adapter (AC	Verify that your adapter is connected correctly. See “Power
or auto/airline) is not	Sources” on page 48.
plugged in properly.

107 - Troubleshooting Your LifeBook