Fujitsu MHV2100AT, MHV2080AT, MHV2120AT, MHV2040AT, MHV2060AT manual Illustrations, Figures

Contents

Illustrations

Figures

Figure 1.1	Negative voltage at +5 V when power is turned off	......................... 1-6
Figure 1.2	Current fluctuation (Typ.) at +5 V when power is
	turned on	1-8
Figure 2.1	Disk drive outer view	2-2
Figure 2.2	1 drive system configuration	2-3
Figure 2.3	2 drives configuration	2-4
Figure 3.1	Dimensions	3-2
Figure 3.2	Orientation	3-3
Figure 3.3	Mounting frame structure	3-4
Figure 3.4	Location of breather	3-5
Figure 3.5	Surface temperature measurement points	3-6
Figure 3.6	Service area	3-7
Figure 3.7	Handling cautions	3-8
Figure 3.8	Connector locations	3-9
Figure 3.9	Cable connections	3-10
Figure 3.10	Power supply connector pins (CN1)	3-11
Figure 3.11	Jumper location	3-11
Figure 3.12	Factory default setting	3-12
Figure 3.13 Jumper setting of master or slave drive		3-12
Figure 3.14	CSEL setting	3-13
Figure 3.15	Example (1) of cable select	3-13
Figure 3.16	Example (2) of cable select	3-14
Figure 4.1	Power supply configuration	4-4
Figure 4.2	Circuit configuration	4-5
Figure 4.3	Power-on operation sequence	4-6
Figure 4.4	Read/write circuit block diagram	4-9
Figure 4.5 Frequency characteristic of programmable filter		4-10
Figure 4.6	Block diagram of servo control circuit	4-12
Figure 4.7	Physical sector servo configuration on disk surface	4-16
Figure 4.8	Servo frame format	4-17
Figure 5.1	Interface signals	5-2

xvi C141-E218