Fujitsu MHV2080AT, MHV2100AT, MHV2120AT, MHV2040AT, MHV2060AT manual Recalibrate X’10’ to X’1F’

Interface

(1) RECALIBRATE (X’10’ to X’1F’)

This command performs the calibration. Upon receipt of this command, the device sets BSY bit of the Status register and performs a calibration. When the device completes the calibration, the device updates the Status register, clears the BSY bit, and generates an interrupt.

This command can be issued in the LBA mode.

At command issuance (I/O registers setting contents)

1F7H(CM)	0	0	0	1	x	x	x	x
1F6H(DH)	x	x	x	DV	xx
1F5H(CH)	xx
1F4H(CL)	xx
1F3H(SN)	xx
1F2H(SC)	xx
1F1H(FR)	xx

At command completion (I/O registers contents to be read)

1F7H(ST)	Status information
1F6H(DH)	x	x	x	DV	xx
1F5H(CH)	xx
1F4H(CL)	xx
1F3H(SN)	xx
1F2H(SC)	xx
1F1H(ER)	Error information

Note:

Also executable in LBA mode.

5-20 C141-E218