Fujitsu PRN608-S user manual Maintenance

PRN608-S

	3.8.18		Italic off	3-24
	3.8.19		Italic on	3-24
	3.8.20		Initialise Printer	3-24
	3.8.21		Request Software version	3-25
	3.8.22		Request Status	3-25
	3.8.23		Request Analog voltage	3-25
	3.8.24		Request Temperature	3-25
	3.8.25		Sub command set	3-26
	3.8.26		Upgrade command	3-26
	3.8.27		Set auxiliary output	3-26
	3.8.28		Automatic sending status	3-26
	3.8.29		Stop sending automatic status	3-27
	3.8.30		Color/Grey scale graphic	3-27
	3.8.31		Enable saving data	3-27
	3.8.32		Save data to board	3-27
	3.8.33		Change dot size	3-28
	3.8.34		Change form feed length	3-28
	3.8.35		Change baud rate	3-28
	3.8.36		Change form feed time	3-28
	3.8.37		Feed Paper	3-29
	3.8.38		Compensate Burn time	3-29
	3.8.39		Bar code width setting	3-29
	3.8.40		Bar code height setting	3-30
	3.8.41		Bar code printing	3-30
	3.8.42		Black Mark	3-32
	3.8.43		Graphic data – non compressed	3-33
	3.8.44		Graphic data – compressed	3-33
	3.8.45		Escape sequences, overview	3-34
4	MAINTENANCE			4-36
	4.1	DAILY USE		4-36
	4.2	STORE/TRANSPORT		4-36
5	SPECIFICATIONS			5-37
	5.1	ELECTRICAL DATA		5-37
	5.2	MECHANICAL DATA		5-37
	5.3	ENVIRONMENTAL DATA		5-37
	5.4	EMC & ESC		5-37
	5.5	TEMPERATURE TEST		5-38
6	CONNECTOR PIN ASSIGNMENT			6-39
	6.1.1		Thermal Head connector	6-39
	6.1.2		Thermal Head connector	6-39
	6.1.3		IRDA connector	6-40
	6.1.4		Cutter connector	6-40
	6.1.5		AUX INPUT connector	6-40
	6.1.6		Power connector	6-41
	6.1.7		USB connector	6-41
	6.1.8		AUX connector	6-42
	6.1.9		Serial connector	6-42
	6.2	MECHANICAL DRAWINGS		6-43
7	APPENDIX			7-44
	7.1	SEIKO COMPATIBLE COMMAND SET (OPTIONAL)		7-44
	7.1.1		Escape sequences, overview	7-44
	7.2	FUJITSU COMPATIBLE COMMAND SET (OPTIONAL)		7-45

28-03-2003 Page 1-5 of 53