PRN608-S
3.8.29 Stop sending automatic status |
|
|
|
|
[Name] | Stop sending automatic status | |||
[Format] | ASCII | ESC b |
| |
| Hex | 1B | 62 |
|
| Decimal | 27 | 98 |
|
[Description] | When this command is sent then it will turn | |||
| off transmitting status. | |||
3.8.30 Color/Grey scale graphic |
|
|
|
|
[Name] | Colour / Grey scale graphic | |||
[Format] | ASCII | ESC c | n | |
| Hex | 1B | 63 | n |
| Decimal | 27 | 99 | n |
[Description] | When this command is sent then will the | |||
| board not feed. After the next graphic data | |||
| (both compression and not). The n is a | |||
| percent of the burn ratio, n can be from 0 to | |||
| 15, and the burn ratio is 100/15*n. This | |||
| command is used by the driver to make | |||
| colour and grey scales printout. | |||
3.8.31 Enable saving data |
|
|
|
|
[Name] | Enable saving data |
| ||
[Format] | ASCII | ESC d |
| |
| Hex | 1B | 64 |
|
| Decimal | 27 | 100 |
|
[Description] | This command will enable that the boards | |||
| save values to the flash, this is made to |
ensure that a wrong transmission not will change settings in the board, remember to send the command “Saving data to board”, to actual save the data.
3.8.32 Save data to board |
|
|
|
[Name] | Save data to board | ||
[Format] | ASCII | ESC e | |
| Hex | 1B | 65 |
| Decimal | 27 | 101 |
[Description] | This command saves all settings to flash. |