26
Chapter 1 Overview
fPower supply unit status LED (on the redundant power supply only)
This LED is on, depending on the power supply unit status as follows.
gSystem status LED / System identification LED
This LED lights or blinks in amber when an error is detected in the server components. If this
LED lights or blinks, refer to "Contact Information" in "Start Guide", and contact your
maintenance engineer or device administrator.
This LED is lit when the server is in standby mode (when the AC pow er is on and the DC power
is off), but this does not indicate an error.
When pressing the system identification LED button located on the front of the server, the front
and rear LEDs are lit blue so that the locations of devices being maintained can be determined.
Also, the [System Identification LED Display] button of ServerView can be used to light them.
hKeyboard port ( )
A keyboard is plugged in.
iMouse port ( )
A mouse is plugged in.
jSerial port ( )
Cables of peripheral equipment conforming to the RS-232C standard such as modems are
plugged in.
The left port is Serial Port 1, and the right port is Serial Port 2.
Serial Port 1 (left) can be used for server management when the setting is changed with the BIOS
Setup Utility. For how to use the server management port, refer to "Appendix C Using the Server
Management Port" (pg.306).
kUSB port ( )
Connects peripheral equipment conforming to the USB standard (2.0 or 1.1).
lDisplay port ( )
A display cable is plugged in.
mParallel port ( ) (optional)
A printer cable is plugged using the optional parallel port expansion kit.
table: Meaning of the Power Supply Unit Status LED
LED status Power supply unit status
Lights in red Failure detected
Off Power off or normal power supply