34
Chapter 1 Overview
1.4.3 Turning On the Server
1Slide the drive cover.
"1.4.1 Sliding the Drive Cover" (pg.31)
2Make sure that the floppy disk drive and CD-ROM drives are empty.
3Turn on the display and peripheral devices.
4Turn the main switch on the server rear panel to "1".
Once you turn it to "1", you do not have to activate it every time y ou start up the server. Turn
this switch only when it is set to "0".
• Do not move, strike, or shake the server when it is turned on. This can damage
the hard disk in the server and cause data loss.
• Turn the server on when the temperature is in its operating environment range
(10-35°C). For details about the operating environment, refer to "Start Guide"
and "Safety Precautions".
When operating the device outside of this operating environment, the server
may operate improperly, damage data etc.
Furthermore, Fujitsu cannot be held responsible for any related damage, malfunction,
or loss of data, etc.
• The fans rotate at high speed immediately after the server is turned on, but this
is not defective. When the temperature is in the server's operating environment
range (10-35°C), they start to rotate at normal speed later.
Also, when the ServerView is installed, the fans rotate at high speed after the
OS is started, but this is not defective. When the temperature is in the server's
operating environment range (10-35°C), they start to rotate at normal speed
later.
• Be sure to wait for 10 seconds or more after shutdown before turning the
server on.