268
Chapter 9 Operation and Maintenance

■SCSI Device (Internal/External)

●The unit does not operate properly.

• Check to see whether the internal cable is connected properly. If it is not connected, correctly connect

the internal cable. For the connection location, refer to "7.7.2 Installable 5-inch Internal Devices and

Notes" (Pg.215).

• For SCSI devices, check to see whether the SCSI ID and terminator are set correctly. If they are not

set, correctly set the SCSI ID and terminator.

9.2.2 Error Messages

■POST Error Messages

This section explains error messages of Power On Self Test (POST: a device check performed during the

server startup).

If an error occurs during POST, the following messages are displayed.

When checking/changing the settings of the BIOS Setup Utility, refer to "8.2 BIOS Setup Utility"
(Pg.231).
For instructions on checking peripheral connections, refer to "Start Guide".
For details on installing hardware options, refer to "Chapter 7 Installing Hardware Options" (Pg.173).
table: List of POST Errors
Message Description
Failure Fixed Disk 0 The IDE device is abnormal. From the BIOS Setup Utility,
check the [IDE Drive1 - 4] setting of the [Main] menu or the
[Local Bus IDE adapter] setting of the [Advanced] menu ->
[Peripheral Configuration] submenu. If the message still
appears, the baseboard must be replaced. Refer to "Contact
Information" in "Start Guide", and contact your maintenance
engineer.
Failure Fixed Disk 1
Fixed Disk Controller Failure
Keyboard error The Keyboard is abnormal. Check to see whether the keyboard
is connected properly. If the message still appears, the
keyboard must be replaced.
Keyboard locked - Unlock key switch
Keyboard controller error The keyboard controller is abnormal. Replace the keyboard or
mouse. If the message still appears, the baseboard must be
replaced. Refer to "Contact Information" in "Start Guide", and
contact your maintenance engineer.
Keyboard error nn The key entry is invalid. If something is pressing the keyboard
keys, remove it. ("nn" is a hexadecimal code representing a
key.) Check to see whether the keyboard is connected properly.
If the message still appears, the keyboard must be replaced.
Stuck Key nn
Monitor type does not match CMOS - Run
Setup
The baseboard is abnormal. It must be replaced. Refer to
"Contact Information" in "Start Guide", and contact your
maintenance engineer.