1-16
ITU channels
To select the scan group (band or channel, including user channels), shift the cursor to either the
position of the band or channel number by pressing the [CURS/2] key. (Band scan is useful to
watch frequencies on the same channel in different bands.)
2. Press the [SCAN/6] key, and “SCAN” appears. The receiver starts scanning, stopping at a
channel where the signal is stronger than the scan-stop level. The receiver will restart scan-
ning when the traffic goes out of that channel or designated time elapses, depending on
system setting 9952.
For example, the scan group is “channel” and scan starts at ITU 1203, as shown in Figure 1-
12.
TR0246810S
J3E
AGC NB SWEEP SCAN
ITU
DUP
Figure 1-12 Sample “scan” screen
3. To stop scanning, press the [SCAN/6] key. “SCAN” disappears from the operation display .