INSTALLATION Continued
2.Install the left and right support brackets (part # 4523226 and 4523227) using the 2 screws removed in step 1 (detail I) and one additional screw on both sides of the range, and center support bracket (part # 4523282) with the four screws removed in step 1 (detail II)..
INSERTED
SCREWS
DETAIL I
ALL 60" MODELS
4 INSERTED 
SCREWS 
DETAIL II
FOR 60" RANGES
WITH STANDARD OVEN
4 INSERTED 
SCREWS 
DETAIL II
FOR 60" RANGES
WITH CONVECTION OVEN
3.Slide the salamander down into the support brackets installed in step 2, see figure 3..
4.Once the salamander is in place, fasten it to the unit on both sides of the range with the provided #14B x 5/8 hex washer head tapping screws (detail I) and the center to the support bracket using 4 of the provided screws (detail II)..
PROVIDED #14B x 5/8 HEX WASHER HEAD TAPPING SCREWS
DETAIL I
ALL 60" RANGES
4 PROVIDED
SCREWS 
DETAIL II
ALL 60" RANGES
Wall Or Counter Mounted Salamanders
Model UIR36C
1.Clearance from combustible construction must be six inches (6”, 152mm) minimum at the rear and six inches (6”, 152mm) minimum at both sides..
The appliance shall be located with respect to building construction and other equipment so as to permit access to the appliance.. Such access and clearance may be necessary for service and cleaning..
2.Counter models are furnished with 4” (102mm) legs.. Level the unit with a carpenter’s level and make minor adjustments with the threaded leg feet.. Ensure that the counter top can support the weight of the appliance prior to installation and is comprised of
Part # 4523974 (11/07) | Page 13 |
