GarrettCom 6K25 manual Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber

Magnum 6K25 Managed Fiber Switch Installation and User Guide (04/06)

for normal status viewing from that direction. Of course, with management, the port status data is also available in software.

2.2.2 Eight-port SFF fiber modules (6K8-MTRJ, 6K8-MLC), 100Mb fiber

1 3 5 7

ACT					ACT
F/H					F/H
ACT					ACT
F/H	LK	LK	LK	LK	F/H
ACT					ACT
F/H					F/H
ACT					ACT
	LK 2	4 LK	6LK	8LK
F/H					F/H

Fig.2.2.2 :

SFF Fiber Port Modules,

6K8-MTRJ (to the left) and

6K8-MLC or -SLC (below)

In an eight-port SFF fiber port module, all of the fiber ports are of the same speed (100Mb), mode, and connector type. Models are available with Small Form Factor

										(SFF) are multi-mode MT-RJ or LC-
	1		3		5		7			type connectors, and single-mode
AC									ACT
F/H									F/H	LC-type connectors.
AC									ACT
	2		4		6		8			The 100Mb fiber eight-
AC									ACT
F/H									F/H	port modules for the Magnum
AC									ACT
F/H	LK			LK		LK		L	F/H
		2	4		6		8			6K25’s normally are set (factory

default) to operate in full-duplex mode for best fiber distance and performance. Using the 6K25’s MNS software, the user may select full- or half-duplex mode per-port through set-up of the software (See Magnum 6K25 MNS Software Manual) for the flexibility to adapt to any FDX or HDX type of Fast Ethernet devices).

There are three LED’s per fiber port. The Link (LK) LED indicates “ready for operation” on that port when lit, the F/H LED indicates operation in full-duplex mode when ON (half-duplex when OFF), and the blinking ACT LED indicates receiving Activity on the port. A fiber cable must be connected into a SFF port and the Link (LK) indicator for that port must be ON (indicating there is a powered-up device at the other end of the cable) in order for a LK LED to provide valid indications of operating conditions on that port.

www . GarrettCom . com

10