GarrettCom 6K25 manual Fig. the top 8-RJ45

Magnum 6K25 Managed Fiber Switch Installation and User Guide (04/06)

The PoE RJ-45 ports act similar to regular RJ-45 ports, except they have capability of providing power on each port to power up the PD devices, per the

		6KP8-45RJ					IEEE802.3af PoE
							standard. The Power
8 Port@ 10/100Mb Copper ports
							Pass-through PoE
						2	modules are totally
		1	3	5			dependent upon the
	10/10			LK/AC		1	powerful -48VDC
	F/ H	2	4	POE			input power supply to
				6			support more RJ-45
	10/10			LK/AC
					4	3	(10/100) ports. Each
	F/H			POE			port require atleast
1	LK/ACT		2	10/10			15watts to power up the
	LINK						PoE PD devices. In this
3	PoE		4	FULL/HALF			Fig. the top 8-RJ45
							ports are enhanced with

POE option The 8-RJ45

POE module are also available with mix –n-match with fiber modules. Please check the ordering information Sec.1.2 for all the various P6K PoE modules option.

The LEDs on 6KP8-RJ45- PoE module are slightly different compared to regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the PoE LED is ON when connected properly to a 803.af compliant PD device on that port. When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data traffic is not affected by PoE.

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED that is marked as LINK/ACT, as shown in the diagram.

PoE LEDs Summary

•For PoE devices, each RJ-45 PoE port supports only 802.3af complaint devices. The PoE LED is ON when the attached PD is drawing power from the port.

•For non-PoE devices connected, the PoE port will act as a normal RJ-45 port and the PoE LED is OFF. No power is being sent out from the port.

•The PoE ports in Magnum 6K’s with 48VDC power input act as a pass- through, so the 48VDC power source must be strong enough to provide power to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to 15 watts per PoE port).

•In the case where the 48VDC power in not internally connected and no power is coming to the PoE ports for some reason, all the PoE port LEDs are ON simultaneously to indicate a trouble condition. The ports will still operate properly for data traffic.

5.2.126KP8-45-2MT, 6@ 10/100Mbps RJ-45 and 2@100Mb multi-mode FX , MTRJ Small-Form-Factor

www. GarrettCom . com

50