Magnum 6K25 Managed Fiber Switch

Installation and User Guide (04/06)

Address Learning

All Magnum 6K25 units have address table capacities of 4K node addresses suitable for use in larger networks. They are self-learning, so as nodes are added, removed or moved from one segment to another, the 6K25 Switch automatically keeps up with node locations.

An address-aging algorithm causes least-used addresses to fall out in favor of frequently-used addresses. To reset the address buffer, cycle power down-and-up.

4.2Status LEDs

For all Magnum 6K25 models :

PWR

: Power LED, ON when external power is applied to the unit.

LK

: Steady ON, Link status for 10 Mbps and 100Mbps operation.

ACT

: ON with port activity for 10 Mbps and 100Mbps operation.

F/H

: Full / Half duplex LED, ON when the port is running full

 

duplex, OFF for half duplex.

100/10

: Speed LED, ON when the speed is 100Mbps , OFF when the

 

speed is 10 Mbps

4.3Up-link MDI-MDIX on RJ-45 port modules, for port 1 only

The upper part of the copper port module has a manual Up-link switch, located

on the inside of the unit on the port module board next to the RJ45 port # 1 which it controls. It enables the port’s cable to be cascaded (X) to a 10/100Mb repeater or switching hub in the network. The manual Up-link switch position is configured as (=) position as default factory setting, where used for all-copper module or combo modules.

4.4Auto-Cross(MDIX) and Auto-negotiation, for RJ-45 ports

The RJ-45 ports independently support auto-cross (MDI or MDIX) in auto-negotiation mode and will work properly with all the other connected devices with RJ-45 port whether it supports Auto-negotiation or not (e.g 10Mb Hub, media converter) or fixed mode at 10Mb or 100Mb Half/Full Duplex(managed switch). No cross-over cable is required while using the 6K8’s copper port to other devices. Operation is according to the IEEE 802.3u standard.

The Managed 6K25-Series Fast Ethernet copper ports, can be set for either fixed 100Mb speed or for 10/100 F/H N-way auto-negotiation per the IEEE802.3u standard. The selection is made via MNS software. The factory default setting is for auto-negotiation. At 10Mb or 100Mb-fixed speed, the user may select half- or full-duplex mode by MNS Software for each RJ-45 port separately. For detail information See Section (10.1 at

page no.52) of this manual to access the “6K-MNS(Rel 3) Software user guide”

www . GarrettCom . com

36

Page 43
Image 43
GarrettCom 6K25 manual Status LEDs, Up-link MDI-MDIX on RJ-45 port modules, for port 1 only