GarrettCom manual Installing 6KPM Cards in the Magnum 6K8-Series

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

Figure 3.6.1d: Removing PM screens Plate

Once opened all the four retaining screws the front cover can be removed easily as shown in Fig 3.6.1d. (To the left).

Carefully remove the PM screen plate using finger or small screwdriver to come out easily as shown in Fig 3.6.1d on the right. Just be careful on the LEDs placed both side and hold

the faceplate tightly. There are no screws used on holding the screen faceplate.

Figure 3.6.1d: Removing Face Plate

3.6.2Installing 6KPM Cards in the Magnum 6K8-Series

Only one front-mounted 6KPMV Module may be installed in one Magnum 6K8-Series Field Switch unit. Follow these steps to install a 6KPMV.

Step 1. Remove top chassis cover. See procedure in Section 3.6.1 above.

Fig 3.6.2a A Magnum 6K8 unit with main board (motherboard) only

Step 2. Place Granddaughter board (as shown in fig. 3.6.2b) on the chassis built in stand off (female) provided at the front of the 6K8-Series Main Board. To place the Granddaughter board

Fig 3.6.2b Granddaughter Board shown separately

on the chassis, as shown in Figure below 3.6.2c, screw down tightly with the three 5/16 stand off (male) on the top of the Granddaughter board. The three 5/16 stand off has been used to place the daughter board on the top of the granddaughter board and a latch

www . GarrettCom . com

38