Magnum 6KP6, Mode 100Mbps fiber optic | GarrettCom 6K8 specification

4 Port@ 10/100Mbps and 2 @100 Mb SC Fiber Port 2

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

module with two 10Mb + two 100Mb multi-mode fiber module and in combine 4 ST- Fiber ports. All four-fiber ports are ST connectors and configured as 10Mb half duplex by default for 10Mb fiber and 100Mb Full duplex for the 100Mb fiber. The 10Mb ST- fiber ports allow the user to connect their legacy 10Mb network to the Magnum 6K8- Series switch. They also provide a convenient way for the half duplex hub to connect to the switch through 10Mb fiber ports. Whereas the 100Mb ST fiber module, allow to connect the 100Mb demand of Switch devices. It supports distances according to the 10Base-FL standard i.e., 2Km distance for multi-mode fiber. (Single-mode for 10Km distance may be available as a special order).

Each port has an Activity (ACT) LED indicating packets being received, a Link (LK) LED indicating proper connectivity with the remote device when lit, and FDX/HDX LED indicating full-duplex mode when lit (or half-duplex if off).

5.2.2.6KP6-RJMSC 4@10/100Mbps RJ-45 and 2@100Mb multi-mode FX- SC “snap-in” Fiber connector

The Magnum 6KP6-

6KP6-RJMSC,

RJMSC is also a Combo 6 Port

module equipped with 4 10/100Mb

1

3

5

7

RJ-45 ports along with 2 multi-

10/100

LK

ACT

mode 100Mbps fiber optic

F/H

4

ACT

ACT

F/H

F/H

transceivers all in one module. This

TX

LK

RX

1

2 TX LK RX

6

LINK

2

10/100

is similar to the 6K6-RJMST. It has

the same LEDs indicating port

3

ACTIVITY

4

FULL/HALF

activity (ACT), Link (LK), and

FDX / HDX and 10/100 operation, and the same faceplate lettering.

1

3

While the functionality of these two modules is essentially the same, the 6KP6- RJMSC is equipped with an SC-type "snap-in" connector instead of an ST-type.

www . GarrettCom . com

52

Image 57

GarrettCom 6K8 manual Magnum 6KP6, Mode 100Mbps fiber optic, Transceivers all in one module. This, Activity ACT, Link LK

Contents

Industrial Field Switch Trademarks Canadian Emission Contacting GarrettCom, Inc Table of Contents InstallationIntroduction 14 6KM-BLNK Troubleshooting Overview Magnum Line Performance Technical SpecificationsNetwork Standards and Compliance, hardware Maximum 10 Mbps Ethernet Segment Lengths Fiber Single-mode connector types Fiber Multi-mode connector types supportedAlarm Relay Contacts Management Console connector Per-port MDI or Mdix on RJ-45 DC Power Supply OptionsMountings Agency Approvals Magnum 6K8 Configuration Options Ordering InformationMagnum 6K8 Port Modules GBIC1000Mb Transceiver options for Mangum 6K8-Series Introduction Inspecting the Package and Product Product Description Magnum 6K8-Series 6K8 1a Magnum 6K8-Series, Industrial Field Switch Www . GarrettCom . com Operate in full-duplex mode for best Normally are set factory default toFiber distance and performance. Using Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb Fiber Speed when on and at 10 MB When lit. The 10/100 LED Indicates operation at 100MbSpeed when OFF when auto Negotiation is not disabled FDX/HDX LED is on to ST or SC @RJ-45 + 2@ 100Mb Four-Port 10 MB and 100Mb mm Fiber ST Modules Gigabit 1000Mbps port modules 7a GBPM-2OTX Two Gigabit port option Packet Prioritization, 802.1p QOS Gbic Description Managed Network Software MNS-6K for Magnum 6K8-Series Frame Buffering and Flow Control Www . GarrettCom . com „ Large selection of built-in fiber options at 10/100/1000Mb Applications Interne Control Center Scada Mounting Instructions Connecting Ethernet Media Locating Magnum 6K8-Series SwitchesIeee Standard Media Type Max. Distance Port Module Fiber Copper Connecting Fiber Optic ST-type, twist-lock Connecting Fiber Optic SC-type, Snap-InConnecting Single-Mode Fiber Optic 100BASE-TX Media Ieee Standard Www . GarrettCom . com DIN-Rail Mounting Quantity Description Din-Rail kit Installation procedures Www . GarrettCom . com Mounting Dimensions for 6K8 with metal brackets Powering the Magnum 6K8-Series Industrial Field Switch Www . GarrettCom . com Preparation for Installing and Removing 6KPMVs from 6K8’s 6K8-Series Port Module 6KPMV Installation 1a Removing the Top panel from the Chassis base of the unit Remove Chassis Cover Installing 6KPM Cards in the Magnum 6K8-Series 2a a Magnum 6K8 unit with main board motherboard only2b Granddaughter Board shown separately Female latch connector 2h sliding in the top cover onto the chassis base track Removing 6KPM Cards Retaining screws shown by arrows Remove 6KPM CardRemoving a 6KPM Card Enlarged view of Magnum 6K8-Series Console Port area Connecting a Management Console Terminal to Magnum 6K8 Switching Functionality DB-9 Console port connector1 RS-232 DB-9 Console Com port Serial port pin assignments Dual LEDs Status on TOP and Front of the 6K8-Series unit Filtering and ForwardingAddress Learning Auto-Cross Mdix and Auto-negotiation, for RJ-45 ports Flow-control, Ieee 802.3x Standard Www . GarrettCom . com ’cvr 6KP4V 6KPMV Module Description Introduction Magnum 6K8 Industrial Field Switch Port Modules Switch, the copper port Segments. When installed in aDual speed copper ports Magnum 6K8-Series Managed 1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Magnum 6KP6 Mode 100Mbps fiber opticTransceivers all in one module. This Activity ACT, Link LK, 2@100Mbps single Mode FX-SC-type, snap Connector 6KP6-RJSSC 4@10/100Mbps RJ-45 Ports Port@ 100Mbps Multi-Mode Fiber port 5 6KP8-MTRJ, 8 @100Mb multi-mode FX, Mtrj Small-Form-factor Magnum 6KP8-45MT Module is a combo module with Port multi-mode fiber LC connector 10/100Mb 8-Port 9 6KP8-RJ45 Twisted Pair PoE LEDs Summary 45-2MT eight ports Module is a 12a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector GBIC-SXSC Gigabit fiber 1000Mb, multi-mode SC ConnectorStandard 1@ 1000Mb Fiber SC + 2@ 100Mb SC GBPM-2OTX Two Gigabit option Before Calling for Assistance When Calling for Assistance No Problem Found Appendix B Internal DC Power Supply Options B3.0 Applications for DC Powered Ethernet Switches B2.0 -48VDC, 24VDC and 125VDC POWER, Theory of Operation B4.0 6K8-SERIES, -48V, 24, 125 or 5VDC Installation B7.0 Troubleshooting C4.0 Features and Benefits of the DUAL-SOURCE Design C5.1 UL Requirements External Terminal Block on a Magnum 6K8 -48VDC Example Magnum 6K8 -24VDC C6.0 Ordering Information Optional