Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

The default setup on the 10Mb fiber module is half-duplex, which allows the Magnum 6K8-Series Switch to connect to any 10Mb hub or media converter or almost any other device with a 10Mb fiber Ethernet port. The default setting of the 100Mb fiber module is full duplex. User mode-control per port through the MNS “port settings” software is the same as the other 6K8-Series modules.

The fiber ports support fiber-cabling distances according to the 10BASE-FL and 100BASE-FX standards, i.e., 2km distance for multi-mode fiber. (Single-mode for up to greater distance may be available as a special order, request quote).

2.2.7Gigabit (1000Mbps) port modules

The Magnum 6K8-Series offers a wide range of optional Gigabit modules and

one or two Gigabit ports can be configured in one modular slot. The Gigabit modules are the two ports GBPMV-2OTX, the 6KP5V-G4RJ (single Gigabit+4 10/100 RJ-45 ports) or the 6KP3V-G2SC (single Gigabit+2 100Mb fiber ports) as shown below in the figure.

ACT F/

ACT F/

ACT

F/

 

 

 

 

 

 

TX

LK RX

3

TX

LK RX

 

 

 

1

 

 

 

 

10/100

 

 

 

 

 

ACT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F/

 

 

F/

 

 

TX

L

RX

TX

LK

RX

 

 

 

 

 

5 7

L

ACT

1@ 1000Mb Fiber SC + 2@ 100Mb SC

1@ 1000Mb Fiber SC + 4@10/ 100Mb

The 6K82 -Series Modules provide6 a GBIC opening for insertion of industry-standard GBICs to provide Gigabit media flexibility. GBIC models are available for both multi- mode (550m) and single-mode (10, 25, 40, 70) km fiber options. Gigabit copper is also available with new models appearing often.

The 1000Mb Gigabit fiber-port modules on the Magnum 6K8-Series are normally set (factory default) to operate at AUTO mode for best fiber distance and performance. The 1000Mbps SC fiber-optic module on the Gigabit -SX and Gigabit-LX transceivers are compatible with the IEEE 802.3z Gigabit standards.

There are two LEDs mounted on each Gigabit port module. The Gigabit fiber port is by default configured to AUTO mode, and can be fixed at 1000Mbps speed full- duplex mode at any time. The Gigabit fiber port has LEDs that indicate LK (Link status) and ACT (receiving activity) on that port when lit.

www . GarrettCom . com

15

Page 20
Image 20
GarrettCom 6K8 manual Gigabit 1000Mbps port modules