8 With the front of the server facing you, lift the server and insert it into the cabinet from the front, then position the disk guides so they fit into the cabinet rails. (Your server may be different than the server shown in the example.)

9 Install a nut bar or mounting nuts on the front cabinet posts.

Nut bar or mounting nuts

10 Push the server toward the back of the cabinet until the front of the server rails touch the front cabinet posts, then secure with two screws through each server rail.

- OR -

Follow the instructions in “Installing the bezel” on page 18 to attach both handles and secure the server into the cabinet.

Warning You must support the server while installing or removing the front screws and while sliding the server on or off the cabinet rails. If the server is not supported, damage to the server or injury may result.

www.gateway.com

17