Remove the four screws securing the rails to the carrier, then remove the rails.
Follow the instructions in “Opening the server case” on page 38.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
Removing a diskette drive from the converted hard drive bay

To remove a diskette drive from the converted drive bay:

1 Follow the instructions in “Preventing static electricity discharge” on page 37. Make sure that you turn off the server, then unplug the power cord and all other cables connected to the server.

Caution

The diskette drive is not hot-swappable. Before installing or removing

 

the drive, make sure that power is turned off and the power cord is

 

unplugged.

 

 

2

3

4 Pull up on the top of the connector on the backplane marked “Floppy Con” to release the flat flex cable.

5 Push in on the lever at the back of the drive carrier to release the drive carrier from the drive bay, then slide the diskette drive carrier out through the front of the server.

6 Pull up on the top of the connector on the back of the diskette drive and remove the flat flex cable.

7

8 Remove the two screws securing the diskette drive in the carrier, then slide the drive out of the carrier.

9 Follow the instructions in “Installing a diskette in a converted hard drive bay” on page 45 if you are installing a new diskette drive.

10

11

12

- OR -

Follow the instructions in “Installing or replacing a hard drive” on page 53 to install a hard drive.

Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Follow the instructions in “Closing the server case” on page 39.

Reconnect all power cords and peripheral device cables, then turn on the server.

www.gateway.com

49