Unlock the bezel, then remove it by pulling it straight off the server. Follow the instructions in “Opening the server case” on page 38.

Replacing the control panel

Caution

The control panel is not hot-swappable. Before installing or removing

 

the control panel, make sure that power is turned off and the power

 

cord is unplugged.

 

 

To replace the control panel:

1 Follow the instructions in “Preventing static electricity discharge” on page 37. Make sure that you turn off the server, then unplug the power cord and all other cables connected to the server.

2

3

4 Press the blue latch at the back of the control panel, then slide the control panel forward far enough to reach the front panel and USB cable connectors at the back of the panel.

Tips & Tricks

You may need to disconnect the ends of the front panel and USB

 

cables from the system board or backplane to create enough slack

 

in the cables to reach the connectors.

 

 

5 Disconnect the cables from the control panel.

86

www.gateway.com