Installing the bezel

Important The bezel is held in place by the server handles. The handles are also used to slide the server in and out of the rack cabinet when mounted using the optional rails.

To install the bezel:

1 With the server pulled out from the cabinet, align the holes in the handle with the holes in the front side of the server.

2 Attach the handles to the sides of the server with two mounting screws on each side. (Your server may be different than the server shown in the example.)

Mounting screw

Mounting screw

3

4

5

Push the server, with the handles attached, into the cabinet to determine which holes in the front posts of the cabinet that the holes in the handles will line up with.

Install the mounting nuts (nuts equipped with spring clips that come with most server cabinets) into the holes in the front posts of the cabinet.

Push the server into the cabinet again.

18

www.gateway.com