Follow the instructions in “Opening the server case” on page 38.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
Installing or replacing a hard drive

Use this procedure to add or replace hard drives in a drive bay. Your server supports as many as three 1-inch high 3.5-inch (fixed or hot-swap) SATA hard drives. You can purchase additional drives through your Gateway Sales representative.

Important Gateway tests and verifies the operation and compatibility of the drives it sells. Especially in a hot-swap or mission-critical environment, additional or replacement drives must conform to Gateway standards.

Installing a fixed SATA hard drive
Use these instructions only if you have installed the fixed drive kit.

Caution Fixed drives are not hot swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged.

To install a fixed SATA hard drive:

1 Follow the instructions in “Preventing static electricity discharge” on page 37. Make sure that you turn off the server, then unplug the power cord and all other cables connected to the server.

2

3

4 Press the latch on the back of the fixed drive carrier and slide it out of the bay. Store the drive in an anti-static bag.

Drive latch

www.gateway.com

53