CHAPTER 4: Installing Components

6Loosen the two thumbscrews (1) on the back of the cover.

7Slide the cover (2) toward the back of the case, then remove it from the case.

Closing the server case

To close the server case:

1Make sure that all of the internal cables are arranged inside the case so they will not be pinched when you close the case.

2Place the cover on the side of the case, then slide it forward until it snaps into place.

3Tighten the two thumbscrews to hold the cover in place.

4Lock the case cover lock on the front panel of the case, then close the bezel.

5Reconnect the power cords and all other cables.

Installing and removing drives

Your server’s basic configuration includes one optical drive and as many as 10 3.5-inch SATA or SAS hot-swap hard drives. You can also add an optional diskette drive.

As you prepare to install drives, remember:

Before you install a drive, see the drive’s documentation for information on configuring the drive, setting drive jumpers, and attaching cables.

You may need to configure the drives you install using the BIOS Setup utility. Press F2 at startup to open the BIOS Setup utility.

26