CHAPTER 4: Installing Components

6Loosen the thumbscrew (1) holding the power distribution board in place, then slide the power distribution board (2) away from the side of the chassis to release it.

7Lift the power distribution board (3) out of the chassis.

Important

Make sure that the power supply cable box is connected to the power supply connector(s) on the power supply(ies).

8Align the new power distribution board with the power supply cage and the standoffs, then push it down onto the standoffs.

9Slide the power distribution board toward the side of the chassis, then tighten the thumbscrew to secure it to the chassis.

10Reconnect the power cables. See “System board” on page 5 for the location of the connectors on the system board.

11Set the case upright, if required.

12Reinstall the power supply modules by following the instructions in “Replacing a power supply module and power board” on page 42.

13Follow the instructions in “Closing the server case” on page 26.

44