CHAPTER 4: Installing Components

3Using the four screws you removed, install the new hard drive into the drive tray.

Screw

Screw

Screw

Screw

4Make sure that the tray’s release lever is open, then slide the new drive fully into the empty hot-swap drive bay and push the lever back into place.

Filling empty drive bays

Empty drive bays in the server must be filled by drive trays with dummy hard drives installed. With the bezel removed, install the appropriate carrier, then replace the bezel by snapping it into place on the front of the server. Dummy hard drives are included with your server and are installed in unused drive bays.

Installing the optional diskette drive

Caution

The diskette drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord(s) is unplugged.

To install the optional diskette drive:

1Follow the instructions in “Preventing static electricity discharge” on page 24. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

2Follow the instructions in “Opening the server case” on page 25.

3Unlock the bezel (if necessary) and remove it by pulling it from the chassis.

4Push the diskette drive bay cover (EMI shield) (1) in from the front of the server.

30