
CHAPTER 4: Installing Components
7Secure the diskette drive into the carrier with the two screws (6) included in the optional diskette drive installation kit.
8Push the diskette drive assembly into the drive bay until it snaps into place.
9Connect the data and power cables to the back of the diskette drive.
10Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
11Follow the instructions in “Closing the server case” on page 26.
12Reconnect all power cords and peripheral device cables, then turn on the server.
Installing memory
Caution
Use only 667 Mhz compliant,
Your server supports from 512 MB to 32 GB of total memory with
The BIOS configures the memory controller to run in
Memory slots
32