CHAPTER 4: Installing Components
10 Remove the backplane and place it in a static-free bag for storage.
11 Holding the new backplane by the edges only, align it with the locking tabs on the hard drive cage, then place it on the locking tabs and slide it up.
12 Tighten the thumbscrew to secure the backplane to the hard drive cage.
13 Slide the hard drive cage back into the opening in the front of the chassis until it clicks into place.

14Reconnect all cables to the backplane.

Connect to Mezzanine Board

15Replace the system fans by following the instructions in “Replacing system fans” on page 37.

16Set the chassis upright, if necessary.

17Follow the instructions in “Closing the server case” on page 26.

18Reinstall the hot-swap drives back into the server. Make sure that you install the drives into the same bays you removed them from in Step 4. For instructions see “Removing and installing a hard drive” on page 28.

19Replace the bezel by snapping it into place on the front of the server.

46