www.gateway.com

Replacing the hot-swap backplanes

Caution

The hot-swap backplane is not hot-swappable. Before removing or replacing the backplane, you must first turn off the server and all peripheral devices attached to the server, and remove the AC power cord(s) from the power supply or wall outlet.

To replace the hot-swap backplanes:

1Follow the instructions in “Preventing static electricity discharge” on page 24. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

2Follow the instructions in “Opening the server case” on page 25.

3Unlock the bezel (if necessary) and remove it by pulling it straight off the front of the server.

4Remove all of the hot-swap drive carriers from the server and make note of which bay you remove each drive from. For instructions, see “Removing and installing a hard drive” on page 28.

5Lay the chassis on its side to make it easier to work on.

6Remove the system fans following the instructions in “Replacing system fans” on page 37.

7Disconnect all cables from the backplanes.

8Rotate the release latch (1) counter-clockwise, then pull the hard drive cage (2) out of the chassis.

Caution

Pressing or pulling on any components on the backplane could result in damage to the backplane.

Caution

Make sure you do not pinch, bind, or damage any cables as you install the backplane.

9Loosen the thumbscrew (3) holding the backplane on the back of the hard drive cage, then slide the backplane (4) down to disengage the locking tabs.

45