Burners
The holes in the surface burners of your range must be kept clean at all times for proper ignition and an even, unhampered flame.
You should clean the surface burners routinely, especially after bad spillovers, which could clog these holes. Wipe off the surface burners. If heavy spillover occurs, remove the surface burners from the range. The burners lift out for cleaning. Lift up the cooktop and then lift out the surface burners.
NOTE: A screw holds each of the burners in place to keep them from wobbling around during shipment. Remove and discard the shipping screw. Tilt the burner to one side at the end closest to the igniter. This disengages it from the gas valves at the front of the range. It lifts out easily.
To remove
Before putting the surface burner back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes. Then place it back in the range, making sure it is properly seated and level.
Safety Instructions Operating Instructions Care and Cleaning
Control Panel and Knobs
It’s a good idea to wipe the control panel after each use of the oven. Clean with mild soap and water or vinegar and water, rinse with clean water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control
The control knobs may be removed for easier cleaning.
To remove the knob, pull it straight off the stem. Wash the knobs in soap and water or a vinegar and hot water solution but do not soak.
Installation Instructions
Oven Shelves
The shelves can be cleaned by hand using | To remove heavy, |
soap and water or with an abrasive | may use scouring pads. After scrubbing, |
cleaner. After cleaning, rinse the shelves | wash with soapy water, rinse and dry. |
with clean water and dry. |
|
Metal Parts
Do not use steel wool, abrasives, ammonia or commercial oven cleaners.
To safely clean surfaces: wash, rinse and then dry with a soft cloth.
19
Troubleshooting Tips Customer Service
