Read these instructions completely and carefully.
If Range Has Electric Ignition
There are separate ignition devices for the left | In the event of an electrical power failure, the top |
and right hand surface burners. Both of these | burners can still be used. To light a burner, hold a |
ignitors are ON when any knob is turned to the | lighted kitchen match adjacent to the top burner |
LITE setting. The ignitors will spark as long as any | to be used and turn valve knob to LITE. USE |
of the top burner knobs are at the LITE setting. | EXTREME CAUTION. |
Oven Pilot Adjustment
Safety Instructions Operating Instructions
On pilot models remove thermostat knob.
Check position of pilot gas selector to make sure selector is turned to the correct position for the type of gas that is to be used. To change to LP, insert small blade screwdriver in slot and turn fully clockwise so that indicator points to LP. To change to NAT, turn fully counterclockwise so that indicator points to NAT.
■If desired, the gas to the oven pilot can be turned off by turning the selector so the pointer is at the OFF position, midway between the LP and NAT settings. (Thermostat on your range may not appear exactly as shown in diagram.)
■On electric ignition models the gas to the oven burner can be turned off. A manual
Oven pilot selector key
switches from LP to NATPointer (vice versa).
Front view
Care and Cleaning Installation Instructions
Oven Operation
With the oven thermostat dial in the OFF position, light standing pilot on oven burner pilot assembly. On electric ignition models do not attempt to manually light the oven pilot.
Turn the thermostat dial to any temperature setting. The oven pilot flame will enlarge and engulf the mercury bulb. After approximately
The oven can be used during periods of power outage. (See the Using the surface units section.)
With control knob in OFF position, light standing pilot. Flame should appear as shown.
Mercury bulb
Troubleshooting Tips Customer Service
31