GE 164D3333P185-1 owner manual Anti-Tip Bracket Installation Instructions, Tools You Will Need

Read these instructions completely and carefully.

WARNING!

Anti-Tip Bracket

• ALL RANGES CAN TIP

• INJURY COULD RESULT

• INSTALL ANTI-TIP DEVICE PACKED WITH RANGE

• SEE INSTRUCTIONS

Tools You Will Need

■Phillips head screwdriver

■13⁄8″ or adjustable wrench

■Flat blade screwdriver

Anti-Tip Bracket Installation Instructions

Safety Instructions Operating Instructions Care and Cleaning

Anti-tip bracket attaches to the floor to hold either rear range leg. When fastening to the floor, be sure that the screw does not penetrate electrical wiring or plumbing. If you cannot be sure of this, use a shorter screw that will not penetrate through the flooring.

Decide whether the anti-tip bracket will be installed on the right or left side of the range location.

If the bracket side of the range is next to a cabinet, place the bracket against back wall and cabinet.

If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the bracket with its outside edge at this location and against the back wall.

Outside edge of bracket

should be flush with theWall behind range

outside of the range

Adjacent cabinet or final location of range side panel

Screw the bracket securely to the floor with the screw provided. The screw is self-drilling in wood, plywood, particle and chip board, and most metal framing. If attaching to masonry, you can buy suitable screws and/or anchors at hardware stores. Use a masonry drill to drill the required holes.

Anti-tip bracket Wall

Using the wrench, back out the four range legs at least two turns. Level the range. See the Protect Your Floor and Leveling the Range information in the Installation the range section of this manual for leveling information.

Slide the range into place.

Installation Instructions Troubleshooting Tips Customer Service

27