GE 225D1804P001 Installation Instructions, Installation Overview, Injury to persons can result

Installation Instructions

INSTALLING THE ANTI-TIP FLOOR BRACKET (on 21 ft. models)

WARNING

Under certain circumstances, this refrigerator can tip forward.

Injury to persons can result.

Install Anti-Tip Bracket packed with this refrigerator.

1MEASURE CABINET OPENING AVAILABLE VS. REFRIGERATOR WIDTH

Measure width of cabinet opening where refrigerator will be placed, W.

Be sure to account for any countertop overhang, baseboard thickness and any clearance desired. Width, W, should not be less than 36 inches. The refrigerator will be placed approximately in the middle of this opening.

2LOCATING THE ANTI-TIP FLOOR BRACKET

APlace the anti-tip floor bracket locator template (included inside the anti-tip kit) onto the floor up against the rear wall, within W, and in line with the desired location of the RH side of the refrigerator (see Figure 1).

Figure 1 – Installation Overview

2 Wall Holes

Floor – Concrete		Floor Bracket
(2 Holes)
		to Install
Floor – Wood
(2 Holes)		RH Holes
	71⁄4”
		Rear RH
Base		Corner of
Bracket		Cabinet Wall
on the	RH Side of	Locator Template
Refrigerator	Refrigerator	Sheet

BPlace the anti-tip floor bracket onto the locator template with its RH floor holes lined up with the floor holes indicated on the template sheet, approximately 71⁄4” from the edge of the sheet or the RH side of the refrigerator.

Rear Wall

W

REFRIGERATOR

Baseboard

Thickness

or Countertop Overhang (Whichever

Is Greater) Plus Any Desired Clearance

RH Side

C Hold down in position and use the anti-tip floor

bracket as a template for marking the holes

based upon your configuration and type of

construction as shown in Step 3. Mark the hole

locations with a pencil, nail or awl.

NOTE:

• It is REQUIRED to use at least 2 screws to

mount the floor bracket (one on each side of

the anti-tip floor bracket). Both must be into

either the wall or the floor. Figure 2 indicates

all the acceptable mounting configurations

Front

for screws. Identify the screw holes on the

anti-tip floor bracket for your configuration.

16