GE 225D1804P001 About the water filter. on some models, Instructions, Water Filter Cartridge

Instructions	back upper right corner of the refrigerator	replacement filter cartridge is not available.
	About the water filter. (on some models)
	Water Filter Cartridge	Filter Bypass Plug
	The water filter cartridge is located in the	You must use the filter bypass plug when a
Safety	compartment.	The icemaker will not operate without the
	When to Replace the Filter	filter or filter bypass plug.
		Replacement Filters:
	There is a replacement indicator light for the
		To order additional filter cartridges
	water filter cartridge on the temperature
Instructions	display. This light will turn orange to tell you	in the United States, visit our Website,
	that you need to replace the filter soon. The	the yellow pages for the nearest Mabe
		ge.com, or call GE Parts and Accessories,
	filter cartridge should be replaced when the	800.626.2002.
	replacement indicator light turns red or if the	Filter Model GSWF
	flow of water to the dispenser or icemaker
		Customers in Canada should consult
	decreases.
Operating	On models with external dispensers, the top	Service Center.
	of the LCD screen will display, “Replace
	Water Filter.”
	Installing the Filter Cartridge
	If you are replacing the cartridge, first
	remove the old one. Open the cartridge
	cover by pressing in on the tab at the
Installation Instructions	front and pulling down.
	Remove the cartridge by slowly rotating
	it counterclockwise. A small amount of
	water may drip down.
	CAUTION: If air has been
	trapped in the system, the filter cartridge may
	be ejected as it is removed. Use caution when
	removing.

Consumer Support Troubleshooting Tips

(on some models)

RESET

FILTER

(on some models)

6

Remove the protective foil from the end of the cartridge.

Lining up the arrow on the cartridge and the cartridge holder, slowly rotate the cartridge clockwise until it stops. When the cartridge is properly installed, you will feel it “click” as it locks into place. The grip on the end of the cartridge should be positioned vertically. Do not overtighten.

Close the cartridge cover.

Run water from the dispenser for

3 minutes (about 11⁄ 2 gallons) to clear the system and prevent sputtering. See To Use the Dispenser section.

Press and hold the RESET WATER FILTER pad for 3 seconds.

NOTE: A newly-installed water filter cartridge may cause water to spurt from the dispenser.