GE 225D1804P001 About the freezer, Instructions Safety Instructions, Operating, Consumer Support

Instructions Safety Instructions

About the freezer.

Not all features are on all models.

Freezer Shelves and Baskets

A shelf above the ice storage bin

A full-width upper basket in top drawer

An ice storage bin

A shallow full-width upper basket in bottom drawer

Appearance and features may vary	A deep full-width lower basket in
	bottom drawer

Operating

Installation Instructions

Troubleshooting Tips

Appearance may vary

Tab

Appearance may vary

Basket Removal (Top Drawer)

To remove the full-width basket on top freezer drawer models:

Open the top freezer drawer until it stops.

The freezer basket rests on the inside tabs on the drawer slides.

Lift the front end of the basket so that the front two alignment tabs come out of the slide bracket first. Then rotate the front edge of the basket up while lifting the remaining two rear alignment tabs out of the slide bracket.

Make sure the plastic sleeves remain attached to the 4 slots on the slide brackets.

Basket Removal (Bottom Drawer)

To remove the full-width upper basket:

Open the bottom freezer drawer until it stops.

Pull the basket out to the stop location.

Lift the basket up at the front to release it from the slides.

Lift the back up and out of the slide.

When replacing the full-width basket:

Tilt the basket back and lower it down into the drawer. Rotate the basket to a horizontal position and press it down into the

4 alignment tabs.

NOTE: Always be sure that all 4 basket slots are engaged in the slide brackets before sliding back into the freezer.

When replacing the full-width upper basket:

Drop the upper rear wire rail of the basket into place behind the plastic tabs. Then drop the front end of the basket into place and slide the basket back into the closed position.

NOTE: Always be sure to fully close this basket.

Consumer Support

Appearance may vary

To remove the deep full-width lower basket:

Open the bottom freezer drawer until it stops.

Lift the rear of the basket up so the two rear alignment tabs are pulled out of the slide bracket.

Rotate the basket up and out of the drawer.

When replacing the deep full-width lower basket:

Lower the front end of the basket into position so that the two front alignment tabs enter the slide bracket. Then lower the rear of the basket into place, ensuring the two rear alignment tabs are pressed into place in the slide bracket.

NOTE: Always be sure that all 4 basket slots are engaged in the slide brackets before sliding back into the freezer.

10