About the automatic icemaker. | ge.com |
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Safety
Power
Switch
Icemaker
Green | Feeler Arm |
Power Light |
Automatic Icemaker (on some models)
The icemaker will produce seven cubes per
See below for how to access ice and reach the power switch.
If the refrigerator is operated before the water connection is made to the icemaker, set the power switch in the O (off) position.
When the refrigerator has been connected to the water supply, set the power switch to the l (on) position. The icemaker power light will turn green when the freezer light switch is pressed in or when the freezer door is closed.
The icemaker will fill with water when it cools to 15°F
You will hear a buzzing sound each time the icemaker fills with water.
Throw away the first few batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.
NOTE: In homes with
NOTE: Set the power switch to the O (off) position if the water supply is shut off.
Instructions Operating Instructions
To reach the power switch.
Accessing Ice and Reaching the Power Switch
To reach the icemaker power switch, open the top freezer drawer and remove the full- width basket. Always be sure to replace the basket.
To access ice, simply open the bottom freezer drawer and slide out the
Ice
Bucket
To access ice.
Icemaker Accessory Kit
If your refrigerator did not come already | Check the back of the refrigerator for the |
equipped with an automatic icemaker, | specific icemaker kit needed for your model. |
an icemaker accessory kit is available at |
|
extra cost. |
|
HOME | ENERGY SAVER ON | TURBO | ||
| COOL | |||
| FREEZER | REFRIGERATOR | ENERGY | |
HELP | 34 F | |||
SAVER | ||||
LOCK | PRECISE FILL | OPTIONS | DOOR | |
|
| ALARM | ||
Hold for 3 Seconds |
|
|
| |
to activate Lock |
|
|
|
Dispenser Cradle
Spill Shelf
To Use the Dispenser (on some models)
Press the glass gently against the top of the dispenser cradle.
The spill shelf is not
If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the dispenser arm for at least two minutes to remove trapped air from the water line and to fill the water system. To flush out impurities in the water line, throw away the first six glassfuls of water.
Locking the Dispenser
Press the LOCK pad for 3 seconds to lock the dispenser and control panel. To unlock, press and hold the pad again for 3 seconds.
11
Troubleshooting Tips Consumer Support