Instructions
Using the self-cleaningupperoven.
The oven door must be closed and all controls set correctly for the cycle to work properly.
Operating Instructions Safety
How to Delay the Start of Cleaning
Makesure the clock shows the correct time of day.
NOTE: The surface burnersmust be turned off prior to the
Touch the SELF CLEAN pad.
NOTE: If the display shows LOC, touch and hold the GAS/CONTROLLOCKOUT pad for 3 seconds to turn it off. See the Gas/Control Lockout section.
Using the number pads, enter the desired clean time.
Touch the DELAYSTART pad. The earliest start time you can set will appear in the display.
Using the number pads, enter the time of day you want the cleancycle to start.
Touch the START pad.
The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED DOOR light goes off.
The oven shuts off automatically when the clean cycle is complete.
When the LOCKED DOOR light is off, the door will unlock automatically.
■The words LOCK DOOR will flash and the oven control will signal if you set the clean cycle and forget to close the oven door.
■To stop a clean cycle, touch the CLEAR/OFF pad. When the LOCKED DOOR light goes off indicating the oven has cooled below the locking temperature, you may open the door.
Installation | Instructions |
Consumer Support Troubleshooting Tips
After a Clean Cycle
You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.
If white spots remain, removethem with a
These deposits are usually a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat the cycle.
■Youcannot set the oven for cooking until the oven is cool enough for the door to unlock.
■While the oven is
■If the racks become hard to slide, apply a small amount of vegetable oil or cooking oil to a paper towel and wipe the edges of the oven racks with the paper towel.
30
