GE DH2000 wall, Converting Straight-through Operation to Corner Operation, Installation

Installation

Converting Straight-through Operation to Corner Operation

To convert track guides and door-lift for corner operation:

1.Remove the rack guide (A); save the fasteners.

Move (A) and re-attach as shown in the illustration at right.

2.Slide a dish rack through the machine to check the guide to dish rack clearance. The dish rack should move smoothly without binding or tipping on the guides.

3.Disconnect the door-lift bracket (B) connecting the front door and the wall-side door and discard. To seal the holes, Re-install the bolts and lockwashers that held the bracket.

4.Disconnect the door linkage arm (C) from the wall-side door and discard. Re-install the white roller (D) and hardware.

5.Disconnect the door linkage arm (C) from the other door but do not discard.

6.Lift the door handle up and back until the springs relax.

7.Adjust the door spring hooks (E) located at the rear of dishwasher to reduce door spring tension until the front and side doors open and close without binding.

Remove the door-lift bracket connecting the front and wall-side doors.

B

wall

A

wall

C

D

Remove the door-linkage arm from the wall-side door and discard.

Re-install the white roller with existing hardware.

A

Re-adjust the door springs at the rear of the dishwasher then check that the doors open and close without binding.

E

3