Operation
Rinse Sentry Operation Mode
The final rinse water temperature must be a minimum of 180ºF/82ºC during the final rinse cycle to ensure that all wares are sanitized. If for any reason, the hot water temperature in the booster tank cannot provide this temperature, the dishwasher will enter a Rinse Sentry Mode of operation and extend the cycle time.
The Rinse Sentry changes the Normal Operation Mode as described below:
1.The Rinse Sentry constantly monitors the water temperature inside final rinse booster.
2.If the temperature inside the booster heater falls below 180ºF/82ºC then the Rinse Sentry will extend the wash cycle time until the booster heater water temperature reaches the proper temperature.
3.The
4.The RINSE water temperature gauge must be monitored to ensure that a minimum of 180ºF/82ºC is maintained during the rinse cycle.
5.The temperature range for the final rinse water is
6.An extraordinarily long wash cycle may indicate a low incoming water temperature or a problem with the booster heater operation.
DO NOT REMOVE WARES UNTIL THE FINAL RINSE CYCLE HAS
SANITIZED THE WARES AND THE GREEN CYCLE LIGHT GOES OUT.
Automatic Drain Cycle
The dishwasher can be drained automatically when the dishwasher has completed a normal wash cycle or whenever the dishwasher is idle.
To drain the dishwasher:
1.Turn the dishwasher Power Switch OFF. The automatic drain valve will open and the machine will drain.
2.The drain valve will remain open for
3.When
NOTE:
The automatic drain cycle can be repeated after
11