GE DH2000 operation manual Normal Operation Mode

Operation

Normal Operation Mode

		Final Rinse	Pressure	In-cycle
Power	Wash			Light
			Gauge
		Temperature
Switch	Temperature
		Gauge
Door Safety	Gauge
Switch

Follow the instructions below to operate the dishwasher in a Normal Wash Mode. A Rinse Sentry feature holds the dishwasher in a wash mode if the booster heater temperature is below 180ºF/82ºC.

1.Turn the main power on at the main circuit breaker.

2.Make sure the spray arms and the scrap screens are in place.

3.Turn the water supply on.

4.Close the dishwasher front door.

5.Push the dishwasher Power Switch to the ON position. The power switch will illuminate and the machine will fill with water.

6.Check the pressure gauge as the machine fills and make sure the incoming water pressure is between 20-25 psi.

7.Wait up to 10-minutes for the WASH temperature gauge to indicate a minimum of 150ºF/66ºC.

8.Load soiled wares into the dish rack. Place plates, glasses, cups and bowls in a peg rack. Place utensils in a single layer in a flat-bottom rack. Place pots and pans in a flat-bottom rack. Do not overload the dish racks.

9.Slide 1 dish rack into the wash compartment making sure that wares do not interfere with the rotating spray arms. Do not wash more than 1 dish rack at a time.

10.Close the front door fully, the wash cycle will begin automatically. The green in-cycle light will illuminate.

11.The wash cycle time runs for approximately 40-seconds. (continued on next page)

9