w●●QUESmONS?
USE THIS PROBLEM SOLVER
PROBLEM
OWN WLL
NOT WORK
OVEN LIGHT DOES NOT WORK
FOOD DOES NOT BRO~ PROPE~Y
FOOD DOES NOT ROAST OR BAKE PROPERLY
OVEN ~LL NOT
OVEN NOT CLEAN AFTER CLEAN CYCLE (model JCP67)
AUTOMA~C OVEN
~ER DOES NOT WORK PROPERLY
POSS~LE CAUSE
●The plug on the range is not completely inserted in the electrical outlet.
●The circuit breaker in your house has been tripped, or a fuse has been blown.
●The oven controls are not properly set.
c The fight bulb is loose or defective. Tighten or replace.
●The switch operating the oven light is broken. Call for service.
●The OVEN SET knob not set at BROIL.
●The OVEN TEMP knob not set at BROIL.
●Door not left open to the broil stop position as recommended.
●Improper sheE position being used. See the Broiling Guide.
●Food is being cooked on hot pan.
●Cookware not suited for broiling.
●Murninum foil used on the broiler pan and rack has not been fhted properly and slit as recommended.
●The OVEN SET knob not set on BAKE.
●The OVEN TEMP knob not set correctly.
●Shelf position is incorrect.
c kcorrect cookware or cookware of improper size is being used.
●A foil tent was not used when needed to slow down browning during roasting.
●Automatic timer dids not set or not set properly. The clock must be set to time of day and the STOP dial must be set and advanced beyond the time noted on the oven clock.
●The STOP dial was not advanced for long enough.
●Both the OVEN SET and the OVEN TE~ knobs must be set at CLEAN settings.
●When the oven is
●The oven controls are not set properly.
●Heavily soiled ovens rquire
“Heavy spillovers should be cleaned up before starting the clean cycle.
●Check to be certain step by step directions were followed correctly. See the Automatic Timer and Clock section.
SURFACE LIGHT
DOES NOT WORK
SURFACE UNITS NOT FUNCTIOMNG
M you need more help.. cdl, The GE Answer Centerm
●The fluorescent light is loose or defective. Adjust or replace.
●Press the switch for 2 seconds. If the light does not come on, repeat.
●The switch operating the light is broken. Call for service.
●The surface units are not plugged in sofidly.
●The surface unit controls are not properly set.
toll free
800.626.2000
consumer information service
32
