GE JG5P38, JG5P34, JGBP26 manual Orifice Spuds forconvetiingto LpG~s

E CONVERTING SURFACE BURNERS ON MODELS EQUIPPED WITH SEALED BURNERS

(See Step 4 if range is equipped with standard twin burners.)

1.Remove grates, burner caps and burner heads.

2.Using a torxdriver, remove the burner bases by unscrewing the 3 small screws in each base. Lift the burner straight out.

DO NOT disconnect the wires from the burner bases unless the cooktop needs to be raised.

3.Remove the brass orifice spud under each burner base by unscrewing spud from fitting with a 7 mm or a small adjustable wrench (depending on the size of your spuds). Apply a 3/4” wrench to the hex on the gas inlet tube as a back-up when removing spud to prevent the aluminum from tisting.

4.Install or~lce spuds according to one of the

following diagrams (sqe ❑ or ~), for LP gas or natural gas, depending on which you are

converting to.

❑orifice Spuds forconvetiingto LpG~s:

LP otilce spuds are in a small plastic bag packed with this Use and Care Guide. LP otilce spuds have a 2-digit number and the letter “L” on one side. Each orifice spud will also have 1 or 2 grooves on one side, denoting the location on the range where it is to be installed as shown below.

❑OrifiCeSpudsfor ConVetiingto Natu~al Gas:

Natural gas orifice spuds have a 3-digit number on one side. Each orfice spud will also have 1, 2 or 3 grooves on one side, with the letter “N” underneath denoting the location on the range where it is to be installed as shown below.

(continued next page)

45