
HOW TO CONVERT THE RANGE FOR USE WITH 1P GAS OR NATURAL GAS (continued)
5.To prevent leakage, make sure the orifice spuds are securely screwed into the gas inlet tubes. Use a small wrench to hold the inlet tube hex to prevent it from twisting.
6.Put old orifice spuds back in the bag to save for possible future conversion.
N~: If an orifice spud is accidentally dropped, the cooktop
can be ra~sed by
the 2 front clips with a large flat
blade“engagingscrewdriver. e
DO NOT attempt to raise the cooktop without removing all 4 burner bases.
If wires were disconnected to remove the cooktop, feed wires through the burner holes in the cooktop. Attach to each burner electrode terminal carefully, making sure not to bend the terminal. Then lower cooktop until it snaps over the clips.
Electrode
Tall Screw
7.Carefully insert burner bases straight down with the tube over the otilce spud. Replace the screws, making sure the ti~ screw is opposite the burner electrode in each burner base.
❑CONVERTING SURFACE BURNERS ON MODELS EQUIPPED WITH STANDARD TWIN BURNERS (See Step 3 if range is equipped with sealed burners.)
1.Lift cooktop.
2.Lift burner assemblies strai
aside to gain
access to surface/Nat.ral,as LPgas=\ burner spuds.
3.With a 5/16” or a small adjustable wrench, remove each of the four spuds on the surface burner
gas inlet tubes | ., |
and replace them |
|
with the correct gas spuds mounted in a holder at the right rear of the range, above the regulator. Natural gas spuds are brass and LP gas spuds are red or silver. (Mount the spuds that you removed born the inlet tubes back in the holder.) To prevent leakage, make sure spuds are securely screwed into gas inlet tubes.
4.Replace the burner assemblies.
5.Keep all spuds with your range so you have them if you move or get a different gas
Top Burner | Ofice Drill Ske | Color |
Natural Gas | #54 (.0550 Dia.) | Brass |
LP (Propane) | #66 (.0330 Dia.) | Red or Silver |
|
|
|
46
—