PROBLEM

“F- AND A NUMBER” FLASH IN THE DISPLAY

OVEN WILL NOT WORK

TOP BURNERS DO NOT LIGHT OR DO NOT BURN EVENLY

BURNERS HAVE YELLOW- OR YELLOW-TIPPED ~AMES

BURNER FLAMES VERY LARGE OR YELLOW

SURFACE BURNERS

LIGHT BUT OVEN

DOES NOT

SURFACE LIGHT DOES NOT WORK

POSSIBLE CAUSE

*If the time display flashed “F- and a number”, you have a function error code. If function error code appears during the self-cleaning cycle, check oven door latch. The latch handle may have been moved, even if only slightly, from the latched position. Make sure the latch is moved to the right as far as it will go. Press the CLEAWOFF pad. Allow the oven to cool for one hour. Rt the oven back into operation. If the failure code repeats, disconnect all power to the range. Call for service.

*Plug on range is not completely inserted in the electrical outlet.

The circuit breaker in your house has been tripped, or a fuse has been blown.

Oven controls not properly set.

Door left in locked position after cleaning.

Make sure electrical plug is plugged into a live power outlet,

Burner holes on the side or around the top of burner may be clogged. Remove burners (on models with standard twin burners) or burner heads (on models with sealed burners) or burner caps on spill-proof models, and clean them with a sewing needle or twist tie. Make sure you do not enlarge the holes. On spill-proof models, check electrode area for burned-on food or grease.

(A) Yellow flarnes—

(B) Yellow tips on outer

(C) Soft blue flare+

Call for service

cone%Normal for LP gas

Normal for natural gas

If burner flames look Me (A), cdl for service. Normal burner flames should look like (B) or (C), depending on the type of gas you use.

* With LP gas, some yellow tipping on outer cones is normal.

If range is connected to LP gas, check dl steps in the Installation Instructions.

The oven gas shut off valve may have accidentally been moved during cleaning or moving.

To check the oven gas shut off valve on standard twin burner models, raise the cooktop and Iook for the gas shut off lever at the extreme right rear corner. To check the oven gas shut off valve on sealed burner models, remove the storage drawer, broiler drawer or kick panel and look for the gas shut off lever at the back of the range. On some models you may have to remove an access cover also.

Fluorescent bulb is loose or defective. Adjust or replace.

*Switch operating the light is broken. Call for service.

(continued next page)

49

Page 49
Image 49
GE JG5P34, JG5P38, JGBP26 manual Soft blue flare+, Cone%Normal for LP gas