Care and cleaning of the range.

GEAppliances.com

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.

WARNING: If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device is reengaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and cause injury.

How to Remove Protective Shipping Film and Packaging Tape

Instructions Safety

Carefully grasp a corner of the protective shipping film with your fingers and slowly peel it from the appliance surface. Do not use any sharp items to remove the film. Remove all of the film before using the appliance for the first time.

To assure no damage is done to the finish of the product, the safest way to remove the adhesive from packaging tape on new appliances is an application of a household liquid dishwashing detergent. Apply with a soft cloth and allow to soak.

NOTE: The adhesive must be removed from all parts. It cannot be removed if it is baked on.

Instructions Operating

Front right burner (on some models)

Burner cap

Burner head

Electrode

Burner base

Make sure the hole in the burner

head is positioned over the electrode

and that the burner head is fully inserted inside the burner base. A small gap between the base and head is normal.

Burner Caps and Heads

The burner assemblies should be washed regularly and, of course, after spillovers.

Turn all controls off before removing burner parts.

The burner grates, burner heads and burner caps can be removed for easy cleaning.

The electrode of the spark igniter is exposed beyond the surface of the burner base. When cleaning the cooktop, be careful not to snag the electrode of the spark igniter with your cleaning cloth. Damage to the igniter could occur.

To avoid snagging a cloth on the spark igniter, leave the burner heads in place when cleaning the cooktop.

To reassemble, replace the burner head first, then the burner cap and finally the burner grate.

Make sure that the heads and caps are replaced in the correct locations. There is one small, one medium, one large and one extra large burner head

and cap.

Medium burner

Small burner

head and cap

head and cap

Cleaning and Care

Front right burner (on some models), front left burner, back right burner and back left burner

Burner cap

Burner head

Stability

Use a sewing

chamber

needle or

 

twist-tie to

 

unclog the

 

small hole in

Burner base Electrode

the burner

head.

Make sure the slot in the burner head is positioned over the electrode. The burner cap has three to four pins. When replacing the cap, make sure none of the pins sits in the stability chamber.

Be careful not to push in any cooktop controls while cleaning the cooktop. A slight electrical shock might result which could cause you to knock over hot cookware.

Wash burner parts with an all-purpose non-abrasive cleaner and warm water. Soak stubborn soil. Dry them with a cloth—do not reassemble while wet.

CAUTION:DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS IN PLACE.

 

Front of range

(on some models)

 

 

Large burner

 

 

head and cap

 

(on some models)

 

 

Extra large burner

 

 

head and cap

Support Consumer Tips Troubleshooting

33