Gefen EXT-DPKVM-441 Telnet Control, IMPORTANT All IP configuration changes will require the

TELNET CONTROL

5.Use the #sipadd command to set the IP address for the Switcher. Check with a network administrator to obtain an available address, if necessary. DHCP is not supported by this Switcher.

#sipadd 192.168.2.234

New IP set to: 192.168.2.234

After setting the IP address, power-cycle the Switcher for the changes to take effect.

IMPORTANT: All IP configuration changes will require the

Switcher to be power-cycled.

6Specify the IP of the Switcher in the Telnet client. In this example, the IP address is set to 192.168.2.234. Once connected to the Switcher, the Telnet client will display a screen similar to the following:

----------- Welcome to DP441 Telnet Server ----------

You are user number 1 of 3 allowed.

You will be disconnected after 10 minutes of inactivity.

Login: Admin

Password: Admin

Type Cmd:

By default, the user name and password options are enabled by use of the #use_telnet_pass command (see page 20). Once this command is enabled, the Switcher will prompt for both the user name and password. The password cannot be disabled from the login process. Once logged in, the Type Cmd prompt will be displayed.

The Telnet interface uses the same commands and syntax that are used with RS-232 control. See the command list, starting on page 15.

25