Gigabyte GA-EP45-UD3P user manual IDE IDE Connector, SATA22, SATA23, SATA21

7)IDE (IDE Connector)

The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attaching the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices, remember to set the jumpers and the cabling according to the role of the IDE devices (for example, master or slave). (For information about configuring master/slave settings for the IDE devices, read the instructions from the device manufacturers.)

40 39

2 1

8)SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10R, Orange)

The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The ICH10R controller supports RAID 0, RAID 1, RAID 5 and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array.

7

7

				Pin No.	Definition
				1	GND
SATA2_4	SATA2_2	SATA2_0		2	TXP
				3	TXN
			1	4	GND
			1	5	RXN
SATA2_5	SATA2_3	SATA2_1		6	RXP
				7	GND

Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive.

•A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number.

•A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.)

•A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number.

- 25 - Hardware Installation