Gigabyte GA-EP45-UD3P Robust Graphics Booster, Fine CPU Clock Ratio Note, CPU Frequency

CMOS Setup Utility-Copyright (C) 1984-2008 Award Software

MB Intelligent Tweaker(M.I.T.)

>>> MCH/ICH
MCH Core	1.100V	[Auto]
MCH Reference	0.760V	[Auto]
MCH/DRAM Reference	0.750V	[Auto]
ICH I/O	1.500V	[Auto]
ICH Core	1.100V	[Auto]
>>> DRAM
DRAM Voltage	1.800V	[Auto]
DRAM Termination	0.900V	[Auto]
Channel A Reference	0.900V	[Auto]
Channel B Reference	0.900V	[Auto]

Item Help

Menu Level`

KLJI: Move	Enter: Select	+/-/PU/PD: Value	F10: Save	ESC: Exit	F1: General Help
F5: Previous Values		F6: Fail-Safe Defaults		F7: Optimized Defaults

Whether the system will work stably with the overclock/overvoltage settings you made is dependent on your overall system configurations. Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced users only and we recommend you not to alter the default settings to prevent system instability or other unexpected results. (Inadequately alter- ing the settings may result in system's failure to boot. If this occurs, clear the CMOS values and reset the board to default values.)

Robust Graphics Booster

Robust Graphics Booster (R.G.B.) helps to enhance the performance of the graphics chip and memory. Auto allows the BIOS to automatically set the R.G.B. mode based on system configurations. Options are: Auto (default), Fast, Turbo.

CPU Clock Ratio (Note)

Allows you to alter the clock ratio for the installed CPU.

The item is present only if a CPU with unlocked clock ratio is installed.

Fine CPU Clock Ratio (Note)

Allows you to increase the CPU clock ratio set in the CPU Clock Ratio item above by 0.5.

CPU Frequency

Displays the current operating CPU frequency.

********	Clock Chip Control ********
>>>>>	Standard Clock Control

CPU Host Clock Control

Enables or disables the control of CPU host clock. Enabled will allow the CPU Host Frequency item below to be configurable. Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow for automated system reboot, or clear the CMOS values to reset the board to default values. (Default: Disabled)

(Note) This item appears only if you install a CPU that supports this feature.

GA-EP45-UD3P Motherboard - 40 -