47.Wrap the High Cable (81) over a Large Pulley (165). Attach the Large Pulley to the Swivel Bracket (31) with an M10 x 55mm Bolt (127), two M10 Washers (148), two M10 x 6.5mm Spacers (151), and an M10 Nylon Locknut (153).
Tighten the Cable Eyelet (174) as far as possible onto the end of the High Cable (81). Then, tighten the M8 Jam Nut (177) against the Cable Eyelet.
48.Identify the Rear Cable (94). Press the Weight Carriage Block (100) into the Weight Carriage (19). Insert one end of the Rear Cable into the the center of the Weight Carriage Block. Attach the Cable and the Weight Carriage Block to the Weight Carriage with an M10 x 65mm Bolt (137), two M10 Washers (148), two M10 x 20mm Spacers (150), and an M10 Nylon Locknut (153).
49.Route the Rear Cable (94) through the Weight Carriage Frame (18) as shown. Insert a Small Pulley (74) into the slot in the Weight Carriage Frame. Then, insert another Small Pulley (74). Attach each Small Pulley with an M10 x 55mm Bolt (127), two M10 Washers (148), two M10 x 6.5mm Spacers (151), and an M10 Nylon Locknut (153).
47 |
|
|
|
|
153 |
|
|
|
|
148 |
|
|
|
|
151 |
|
|
|
|
31 |
|
|
|
|
81 |
| 148 | 127 |
|
165 |
| |||
|
|
| ||
177 | 174 |
|
| |
|
|
| ||
48 |
|
|
|
|
|
|
|
| 94 |
| 153 | 150 |
| 100 |
| 148 |
| 150 | |
|
| 148 | ||
|
|
|
| |
|
| 19 |
| 137 |
|
|
|
| |
49 |
| 74 |
|
|
|
|
|
| |
153 | 151 | 94 |
| |
Slot |
| |||
|
|
|
| |
148 |
|
| 18 | |
151 |
| 151 | ||
|
| |||
|
|
|
| |
|
|
| 148 | 127 |
25
